Let's look at common issues with windlasses and how to address them. Additionally, we have another article on this topic that may be useful located here.
Windlass Won’t Run in Either Direction
- If your windlass motor doesn’t activate when you use the control, it indicates a power issue.
- Start by checking the circuit breaker designed to prevent electrical fires. Verify voltage on both sides of the breaker.
- Use a voltmeter to test the positive and negative terminals directly on the windlass motor. No voltage suggests a break in battery cables.
- If voltage drops significantly during windlass operation, your electrical system may not provide enough power. Check batteries, cable diameter, and connections.
- It could also be a shortage of power to the up & down switch. Check the connections and clean the terminals. See if the fuse has blown.
Solenoid Clicks, but Windlass Won’t Move
- Inspect the power supply to the windlass motor and all connections.
- Use a voltmeter to check power to and from the solenoid. If no power in either direction, replace the solenoid.
Windlass Lacks Power to Haul the Anchor
- Tighten the windlass clutch by using the windlass handle on the top cap.
- Ensure the rode kit isn’t caught in the chain pipe (deck hole between windlass and anchor locker).
- Cut the hole at an angle to prevent chain/rope entanglement.
- Verify that links move freely, especially with new galvanized chain.
- Check the anchor locker size—sufficient “drop” prevents rode from piling up and jamming.
- Regularly inspect for unnoticed jams that could blow the main fuse.
Rode Gets Jammed or Doesn’t Come In
- Weak battery: Ensure your battery is sufficiently charged.
- Use correct cable sizes specified for your windlass.
- Watch out for blown main fuses under heavy power consumption.
Feel free to contact us if you have questions that aren't addressed here.
